How to Use PADAB Gel
- First, remove contaminants any loose and porous spot with a wire brush, blade, or another appropriate tool from the surface and then clean the desired spot with a wet wipe and let it dry thoroughly.
- – Shake the tube firmly for one minute until the contents are completely soft and mixed. Then open the lid of the tube and apply the gel on the joints, cracks, or other desired spots. Subsequently, level it with a spatula or your fingertips (that are covered with disposable gloves).
- The initial setting of NSG-PADAB occurs in 10 or 20 minutes (depending on the ambient temperature).
- In the meantime, clean the area around the joints or areas that have been inadvertently covered with gel with a blade spatula and a wet wipe cloth so that the gel remains only in the joints and cracks. Note that if you do not do this in time, you can hardly remove the excess gel after it dries.
This material dries after 7 to 12 hours (depending on the ambient temperature) and the desired area can be washed. If possible, do the pointing and sealing when you do not need the place for the next 12 hours.